PUTHON Responder One Installationsanleitung PDF herunterladen (Seite 39)

and shuts down. Programmed to the default setting the engine will run

for 12 minutes. If the 24 or 60 minute run time is desired, change this

feature to the two or three ﬂash setting.

3 PARKING LIGHTS—

CONSTANT

/FLASHING:

In the default setting, the parking lights will come on solidly for the entire

run duration. in the ﬂashing setting, the parking lights will ﬂash for the

entire run duration.

4 CRANK TIME—

0.6

/0.8/1.0/1.2/1.4/1.6/1.8/2.0/4.0 Sec-

onds:

If Feature 2 is programmed to the voltage sense setting, the crank

time must be set to the appropriate duration. The default setting is 0.6

second. If a different crank time is desired, press the Channel Two

button to advance through the LED Off settings. The unit will ﬂash the

LED to indicate which time is selected. Once the 4.0 second setting is

REACHEDTHENEXTPRESSOFTHE#HANNEL4WOBUTTONWILLRESETTHESYSTEM

to the shortest setting.

5 ACTIVATION PULSE COUNT—

/2/3 PULSES:

This feature allows the number of pulses to activate the remote start

feature to be changed from 1, 2, or 3 pulses. The pulse count pro-

grammed to start the vehicle will also be the same required to shut

down the remote start.

6 2nd—

IGNITION

/ACCESSORY OUTPUT:

This will allow the PINK/WHITE to be used as a 2

ignition or a

accessory.

7 ACCESSORY STATE DURING WAIT-TO-START—

OFF

/ON:

This will allow the programming of the accessory wire during the wait-

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 53 54

Keine Kommentare

PUTHON Responder One Installationsanleitung Seite 39